Home » Blackhawk vs ARCAN Floor Jack: Which One Is Yours

Blackhawk vs ARCAN Floor Jack: Which One Is Yours

by Hank Miller
13 views

Last updated: May 2026

The Blackhawk B6350 and the ARCAN A20019 are two of the most searched floor jacks in the home garage category right now — and they are built for completely different vehicles. The B6350 is a 3.5-ton steel jack with a 22-inch max lift built for trucks and full-size SUVs. The A20019 is a 3-ton aluminium low profile jack with a 3.25-inch minimum height built for sports cars and lowered sedans. If you are trying to decide between them, the answer is almost always determined by what you drive — not by price. This comparison is based on manufacturer specifications, long-term owner feedback, and mechanic input rather than controlled lab testing.

Blackhawk B6350 and ARCAN A20019 floor jacks side by side on concrete garage floor
Blackhawk B6350 (left) vs ARCAN A20019 (right) — different jacks, different jobs.

Blackhawk vs ARCAN Floor Jack: Which One Is Yours

Blackhawk B6350 vs ARCAN A20019 • Head to Head • Home Garage Comparison

Quick Verdict

Buy the Blackhawk B6350 if You drive a truck, full-size SUV, or any vehicle needing 20+ inches of lift height
Buy the ARCAN A20019 if You drive a sports car, lowered sedan, or any vehicle that sits close to the ground
Blackhawk score 9.0 / 10
ARCAN score 8.8 / 10
Full comparison See all floor jack options
How this comparison was built: Hank draws on 20 years of automotive tool experience, feedback from his mechanic network, and aggregated verified owner reports across both products. This is not controlled lab testing — it is expert synthesis of the data that exists. When Hank picks a winner in each category, that call is grounded in real-world use patterns, not spec sheet arithmetic.

The Two Jacks

Blackhawk B6350 3.5-ton hydraulic floor jack

Blackhawk B6350

9.0
Hank’s Score

3.5-ton steel floor jack. Dual-piston pump. 22-inch max lift. Built for trucks, full-size SUVs, and heavy garage use.

Check Price

Amazon Associate link

ARCAN A20019 3-ton aluminium low profile floor jack

ARCAN A20019

8.8
Hank’s Score

3-ton aluminium low profile jack. 3.25-inch minimum height. Shop-proven track record. Built for sports cars and low clearance vehicles.

Check Price

Amazon Associate link

Head to Head Specs

Spec Blackhawk B6350 ARCAN A20019
Capacity 3.5 ton (7,700 lbs) ✓ 3 ton (6,600 lbs)
Min Height 5.125 inches 3.25 inches ✓
Max Height 22 inches ✓ 19.5 inches
Pump Dual piston ✓ Single piston
Body Steel Aluminium ✓
Weight ~68 lbs ~56 lbs ✓
Best For Trucks, SUVs Sports cars, sedans
Hydraulic Hold Excellent ✓ Very good
Hank’s Score 9.0 / 10 8.8 / 10

Round by Round

Six categories. One winner per round. No ties unless the difference is genuinely too close to call.

Capacity — Blackhawk wins

3.5 tons versus 3 tons. For trucks and full-size SUVs the extra half ton is not marketing headroom — it is the difference between the right tool and a jack at its limit. For passenger cars the ARCAN’s 3 tons is more than sufficient.

Minimum Height — ARCAN wins

3.25 inches versus 5.125 inches. The ARCAN fits under vehicles the Blackhawk physically cannot reach. For sports cars, lowered sedans, and Teslas this is the only spec that matters. The Blackhawk does not compete here.

Pump Speed — Blackhawk wins

Dual piston versus single piston. The Blackhawk reaches working height in four to five strokes. The ARCAN takes more. For daily shop use that difference adds up. For occasional home garage use it is a minor inconvenience at most.

Portability — ARCAN wins

56 lbs versus 68 lbs. The aluminium body makes the ARCAN noticeably easier to move. Pulling a jack off a shelf, carrying it across a garage, storing it in a tight space — 12 lbs less matters more than it sounds over a period of years.

Hydraulic Hold — Blackhawk wins

Both jacks hold well under their intended loads. Owner reports consistently give the Blackhawk the edge for sustained heavy load performance — the oversized cylinder and steel construction hold up under truck weight in a way the ARCAN, rated for lighter vehicles, is not designed to match. Worth noting: for vehicles operating near the ARCAN’s rated load limit, long-term hold performance becomes more variable according to owner reports. Keep both jacks within their intended weight ranges and this distinction matters less.

Corrosion Resistance — ARCAN wins

Aluminium does not rust. A steel jack stored in a humid garage or a coastal environment will show surface corrosion over time if the coating is compromised. The ARCAN’s aluminium body handles those conditions without issue.

Visual Comparison

Blackhawk B6350 vs ARCAN A20019 floor jack comparison infographic showing capacity, minimum height, weight and best use for trucks versus sports cars

Match the Jack to Your Vehicle

The single fastest way to pick the right jack is to know your vehicle’s ground clearance and its heaviest corner weight. Everything else — brand, price, pump speed — is secondary to those two numbers.

Vehicle Type Recommended Jack Reason
F-150, Silverado, Ram 1500 Blackhawk B6350 Needs 3.5-ton capacity and 20+ inch lift height
F-250, F-350, heavy duty trucks Neither — go 4-ton+ Above both jacks’ rated capacity at full corner load
Toyota Tacoma, Jeep Wrangler Blackhawk B6350 High clearance, moderate weight — Blackhawk fits and handles it
Honda Civic, Toyota Corolla ARCAN A20019 Standard ground clearance, well within 3-ton capacity
Porsche 911, Subaru BRZ, WRX ARCAN A20019 Low sill clearance — ARCAN’s 3.25 in minimum fits cleanly
Tesla Model 3, Model Y ARCAN A20019 Low profile EV — needs low minimum height to reach lift points
Lowered street car ARCAN or GAOLLY If below 3.25 in, the GAOLLY’s 2.8 in minimum goes lower
The one situation where you need both: A home garage with a truck and a sports car. The Blackhawk will not fit under the sports car. The ARCAN does not have the capacity for the truck. If you own both vehicle types, own both jacks. There is no single tool that covers the full range honestly.

Safety Rules for Both Jacks

These apply regardless of which jack you choose.

RULE 1 — Jack stands every time. A floor jack lifts. Jack stands support. Place rated stands before going anywhere near a lifted vehicle. This rule applies to a $50 jack and a $500 jack equally.
RULE 2 — Use factory lift points only. Every vehicle has reinforced contact points specified by the manufacturer. Using the wrong point risks structural damage and an unstable lift. Check your owner’s manual before the first lift on any new vehicle.
RULE 3 — Match the jack to the vehicle weight. The Blackhawk is rated to 3.5 tons. The ARCAN to 3 tons. These are maximums, not suggestions. Operating a jack at or above its rated capacity accelerates seal wear and increases failure risk.
RULE 4 — Bleed before first use. Cycle either jack fully up and down three times with no load before lifting any vehicle. Full guidance at OSHA vehicle lifting standards.

Ready to pick one? Both are on Amazon with current pricing.

See full floor jack category breakdown →

Hank’s Final Call

The Verdict

These two jacks do not actually compete with each other. The Blackhawk B6350 is one of the strongest steel floor jacks for trucks in this price range, based on reported usage patterns and spec comparisons across the category. The ARCAN A20019 is the most proven low profile jack for sports cars and sedans at this price point. Comparing them on a single score misses the point — they are built for different vehicles and different jobs.

If you own a truck: the Blackhawk. The spec differences make that a straightforward call. If you own a sports car or a lowered daily driver: the ARCAN. Again, the specs point clearly in one direction. If you own both: buy both. There is no honest single-jack answer for a mixed garage.

The only scenario where the choice is genuinely difficult is a standard-height crossover or family SUV — something like a RAV4 or CR-V that sits comfortably above 5 inches of clearance but does not weigh anywhere near truck levels. Either jack works there. Based on reported long-term usage patterns, the Blackhawk holds a hydraulic advantage under heavier sustained loads — but the ARCAN’s portability and corrosion resistance make it a reasonable pick for lighter vehicles in that range. It is the closest call in this comparison and reasonable mechanics land on either side of it.

Blackhawk: trucks, SUVs, heavy garage use ARCAN: sports cars, sedans, low clearance vehicles

Who Should Buy Which

Buy the Blackhawk B6350 if you…

  • Own a full-size truck or heavy SUV
  • Need more than 20 inches of lift height
  • Prioritise hydraulic hold over portability
  • Do regular heavy maintenance, not just wheel swaps
  • Work in a shop environment or lift vehicles frequently

Check Blackhawk Price

Amazon Associate link

Buy the ARCAN A20019 if you…

  • Drive a sports car, Tesla, or lowered vehicle
  • Need a jack that fits under 4 inches of clearance
  • Want to carry the jack easily between lifts
  • Store equipment in a tight space
  • Want a shop-proven brand at a home garage price

Check ARCAN Price

Amazon Associate link

Not sure either is right for your vehicle? The Best Hydraulic Jacks guide covers the full category including budget options, the GAOLLY for sub-3-inch clearance, and the Workbench ton rating guide to match any vehicle to the right jack capacity.

Frequently Asked Questions

Can the ARCAN A20019 lift a truck?
The ARCAN is rated to 3 tons (6,600 lbs). A full-size truck like an F-150 can weigh 5,000 to 6,000 lbs, putting 1,500 to 2,000 lbs on a single corner — technically within capacity. However the ARCAN’s 19.5-inch maximum height may not clear the rear axle on a lifted or stock-height full-size truck, and the aluminium construction is not designed for the sustained heavy loads that truck maintenance involves. The Blackhawk B6350 is the right tool for trucks.
Can the Blackhawk B6350 fit under a sports car?
No. The Blackhawk’s minimum saddle height is 5.125 inches. Most sports cars and lowered vehicles sit below that at the factory lift points. The jack will not clear the sill without contacting the bodywork. Use the ARCAN A20019 (3.25 in) or the GAOLLY (2.8 in) for low clearance vehicles.
Which is better for a daily driver sedan like a Honda Civic or Toyota Camry?
The ARCAN A20019 is the better fit for standard-height sedans. The Civic and Camry both sit above 5 inches of ground clearance so the Blackhawk would technically fit, but the ARCAN’s lighter body and lower minimum height make it easier to use on vehicles that sit closer to the ground. Either works — the ARCAN is the more practical choice for that use case.
Is the Blackhawk B6350 worth the extra cost over the ARCAN?
For truck owners, yes. The extra capacity, higher max lift, dual-piston pump, and steel construction justify the price difference when you are lifting vehicles at or near the ARCAN’s weight limits. For sports car and sedan owners, the ARCAN at its price point is the better value — the extra cost of the Blackhawk buys capabilities you will never use on a low-clearance passenger car.
Which jack is easier to store in a small garage?
The ARCAN A20019 at 56 lbs and with its lower profile is easier to store in a tight space. The Blackhawk B6350 at 68 lbs and with a larger footprint takes up more floor or shelf space. If storage space is a constraint, the ARCAN is the more practical choice for vehicles it is rated to handle.
Do I need both jacks if I own a truck and a sports car?
Honestly, yes. There is no single floor jack that handles a full-size truck and a low-clearance sports car without compromise. The Blackhawk will not fit under the sports car. The ARCAN is not designed for sustained truck-weight loads. If you work on both vehicle types regularly, owning both jacks is the practical answer — not a sales pitch.

Sources and transparency: This comparison is based on manufacturer specifications for both products, feedback from Hank’s mechanic network, and aggregated verified owner reports — not controlled lab testing. Safety rules referenced against OSHA vehicle lifting standards. No payment received from Blackhawk or ARCAN. Individual reviews: Blackhawk B6350 full review and ARCAN A20019 full review.

Hank Miller, hydraulic tools expert

Hank Miller

Born in Ohio’s Rust Belt. Over 20 years fixing trucks and heavy gear taught me one thing: good tools keep you safe, bad ones cost fingers. I gather intel from fellow mechanics, dig into owner data, and make the call so you know exactly what you are buying before it goes under your vehicle. Read Hank’s full story.

You may also like

Leave a Comment